Top seller
Any questions?
Request CAD data or ask a question about the product
No results were found for the filter!
Stepped jaws
The hardened and ground step jaws are used for clamping of finished parts or in the second setup
Short clamping jaws 75°
Through the undercut at the jaws, the workpiece is held securely during machining. Only 3 mm clamping depth are necessary.
Grip jaws
For form fit clamping of raw material. The hardened surface of the grip jaws deforms the workpiece surface during the clamping process and thus increases the holding force of the clamping location. The applied coating protects the grip...
Step jaws, rough with coating
For form fit clamping of high-strength raw material. The hardened surface of the clamping jaws deforms the workpiece surface during the clamping process and thus increases the holding force of the clamping location. The applied coating...
Step jaws with carbide coating
The hardened, ground and then carbide coated step jaws are used for clamping of ground finished parts or in the second set-up. High holding force through increased friction factor. The workpiece surface will not be damaged.
Pendulum jaws
The pendulum jaws allow raw material clamping of cast, molded as well as unparallel sawed workpieces. With the pull-down pendulum jaws, angular misalignments of several millimetres can be rectified. The clamping surfaces are rough...
Top jaws MZE
For use together with all standard jaws type MZE as well as customer designed jaws. The top jaws allow the use of short cuting tools especially with small workpieces.
Viewed